Connecting The Pdu - Tripp-Lite PDUMH15AT Manuel Du Propriétaire

2. Installation
2.1B Wall or 2.1C
Mounting: Remove the screws
the mounting brackets to the PDU, change the
orientation of the brackets as shown and
reattach the brackets. Use only the screws
supplied by the manufacturer or their exact
equivalent (#6-32, 1/4" flat head). Attach the
PDU to a stable mounting surface by inserting
two or more user-supplied screws
the PDU mounting brackets
points on the mounting surface.

2.2 Connecting the PDU

The PDU includes two AC power inputs: Primary
and Secondary. The Primary input cord is
permanently attached to the rear of the PDU.
The Secondary input cord is detachable and
connects to the IEC power inlet
of the PDU (PDUMH15AT,PDUMH15ATNET -
IEC-320-C14 inlet; PDUMH20AT,
PDUMH20ATNET - IEC-320-C20 inlet).
2.2A To connect the Secondary input
cord:
1. Form a loop in the Secondary cord
secure the juncture of that loop to the
Primary cord with a zip tie. Be sure the zip
B
tie is secured around the Secondary and
Primary cords, as well as through the loop
created in the Secondary cord
diagram). Note: Give the cord as much slack
as possible between the loop and the cord's
outlet.
2. Once you've secured the two cords together
and ensured that the Secondary cord has a
comfortable amount of slack, insert the
Secondary cord outlet into the IEC power
inlet.
16-11-164-933689.indb 3
(continued)
Under-Counter
attaching
C
through
A
and into secure
B
at the rear
2
and
A
. (See
C
B
2.1B
C
C
2.1C
PDUMH15AT
2.2
PDUMH15ATNET
B
C
B
2.2A
3
C
A
C
B
A
PDUMH20AT
PDUMH20ATNET
A
PDUMH15AT
PDUMH15ATNET
A
C
PDUMH20AT
PDUMH20ATNET
1/4/2017 2:18:44 PM