Mounting The Power Strip; Connecting The Power Strip To The Ats - Tripp-Lite PDU360AT6G60 Manuel De L'utilisateur

All manuals and user guides at all-guides.com
2. Installation

2.2 Mounting the Power Strip

Note: Power strips require a 4-inch installation width
within the rack. Mounting buttons come pre-installed
on the Power Strip for toolless mounting. A second
set of button mounting holes on the Power Strip
allow alternate positioning in the rack.
Position the Power Strip as desired within the
rack enclosure, align the buttons with the rack
mounting slots and slide the Power Strip
downward into position.
Your model may differ slightly from image.

2.3 Connecting the Power Strip to the ATS

The power strip has two 8-conductor plugs.
Each cord is labeled Output 1 and Output 2.
The cord labeled Output 1 must be connected
to the ATS Output 1 receptacle; the cord
labeled Output 2 must be connected to the ATS
Output 2 receptacle.
The power strip also has a 6-conductor circuit
detection cable that requires connection from
the power strip to the ATS unit.
Your model may differ slightly from image.
4
16-01-031-933588.indb 4 3/22/2016 4:14:17 PM