Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
INSTALLATION AND COMMISSIONING
5.1
Unpacking the machine
Machines are delivered from our works on pallets, strapped and protected with cardboard. First of all,
the packaging must be examined and any damage caused in transit must be declared directly to the
carrier.
A. Remove the cardboard.
B. Remove the side doors from the machine in order to gain access to the screws securing
the machine to the pallet.
C. Detach the machine from its pallet by removing the 2 screws immobilising the machine
(fig.5).
D. Take the machine off the pallet. Make sure you do this with at least two people in order to
lower it as gently as possible onto the floor.
E. (TRADIFORM/DIVIFORM/DIVIFORM+) Fit the frame onto its mounting (fig.6).
F. (EASYFLOUR Option) Install the flour dispenser and fill it with flour (fig.6).
After unpacking the machine, check that it has not been damaged in transit. Notify us
of any defects.
5.2
Location
In order to achieve excellent performance and long-term reliability, choose a location that is:
Well ventilated, shielded from direct sunlight and away from sources of heat, with a flat and
sturdy surface free from vibration.
5.3
Electrical connection
IMPORTANT: This machine must be earthed.
It is recommended that the system be protected with a fuse and an RCD.
Your mains electricity supply to the machine must be protected as indicated below:
- North America: 15 A protection;
- Rest of the world: 16A protection.
For machines equipped with a variable speed drive, it is imperative that they be connected to a
junction box on a circuit fitted with a type B 300 mA differential.
Note: Any problem resulting from any other type of connection will not be covered under warranty.
Before connecting the machine to the mains supply and in order to prevent motor failure when it is
switched on, it is important to check that the mains supply matches the machine specification (see
machine nameplate).
9
English
Publicité
Chapitres
Table des Matières
