Device elements
1 Fleece filter bag
2 Suction support
3 Suction hose
4 Nameplate
5 Carrying handle
6 Hose switch
7 Cable clamp
8 Power cord
9 Suction head
10 Suction head lock
11 Steering roller
12 Dirt receptacle
13 Main switch
14 Switch between hard surface/carpet
(depending on model)
15 Floor nozzle
16 Suction tube
17 Suction force regulator (continuous)
(depending on model)
18 Bender
19 Main filter basket
20 Motor protection filter
Check whether main filter basket has
been inserted into the appliance.
Operating modes
1 Operation with filter bag
2 Operation without filter bag
Installation of the filter bag
Release and remove the suction head.
Remove the main filter basket.
Insert the fleece filter bag.
Insert main filter basket.
Insert and lock the suction head.
Operation
Turning on the Appliance
Plug in the mains plug.
Switch on the appliance at the main
switch.
10
Start up
Cleaning operations
Not 1.527-180.0:
Set the selection switch of the floor noz-
zle to hard surface or carpet.
ProT 200 only:
Regulate the suction force on the suc-
tion force regulator (continuous).
Perform the cleaning operation.
Turn off the appliance
Switch off the appliance at the main
switch.
Pull out the mains plug.
After each operation
Empty the container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Clean main filter basket
Main filter basket (washable), clean it
under running water if necessary.
ATTENTION
Risk of damage! Never insert the main filter
basket while wet.
– 2
EN
Transport
Storage