Device Elements; Start Up - Kärcher NT 14/1 Ap Adv Mode D'emploi

Device elements

1 Filter cover
2 Filter dedusting
3 Flat fold filter
4 Handle
5 Suction hose
6 Cable hook, rotating
7 Push handle
8 Suction head lock
9 Chassis
10 Dirt receptacle
11 Steering roller
12 Button for filter shake off system
13 Suction support
14 Chassis lock
15 Floor nozzle
16 Indicator lamp
17 Socket
18 Main switch
19 Suction tube
20 Carrying handle
21 Suction head
22 Electrodes
23 Filter frame lock
24 Filter frame
25 Bender
26 Exhaust filter
27 Suction pipe storage
28 Elbow intake
29 Crevice nozzle storage
30 Exhaust air outlet
31 Power cord
32 Nameplate
ATTENTION
The flat pleated filter must always be in
place while vacuuming.
Anti-static system
Only for appliances with built-in socket:
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks with attachments with electrical
conductivity included in the delivery.
12

Start up

Dry vacuum cleaning
– To vacuum fine dust, you can also use
an additional paper filter bag or a fleece
filter bag.
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Place the paper or fleece filter bag.
 Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
– To vacuum wet dirt, first remove the pa-
per or fleece filter bag.
General
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if mostly wa-
ter is suctioned from a container it is
recommended not to activate the "man-
ual filter dedusting" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
– 2
EN