Symbols On The Appliance; Device Elements; Installation; Startup - Kärcher CV 38/2 Mode D'emploi

Symbols on the appliance

Setting for long pile carpets
Setting for short pile carpets
Filter status indicator (see
"Troubleshooting -Remove the
blockage")
Identifies the access to the roll-
er brush in the side section (see
"Replacing the roller brush")
Type plate
Further important device specifications are
provided on the type plate. The type plate is
located on the rear of the device casing.

Device elements

Mains cable
1
Mains power cable connection
2
Suction pipe/suction hose
3
Brush head lock
4
"Electronic brush monitoring" indicator light
5
Fibre height selection button
6
Filter cover
7
Filter cover lock
8
Main switch
9
Handle
10
Brush cover rotary lock
11
Side section bow
12
Side section
13
Filter bag lock
14
Filter bag
15
Motor protection filter
16
Filter casing
17
Exhaust filter
18
Suction hose at brush head
19
Handle adjustment
20
Cable hook, rotating
21
Cushion nozzle
22
Crevice nozzle
23
"Filter" indicator lamp
24
Indicator tuft
25
Roller brush
26
Install the loose parts for handle provided
with the device before using the device for
the first time.
See page 4 for illustrations
Handle with mains power cable
1
Handle metal tube
2
Suction pipe and suction hose
3
1. Open the handle adjustment.
2. Push the metal pipe of the handle into
the mount all the way to the lowest latch-
ing position (latches audibly twice).
3. Insert the handle into the metal pipe and
latch into place. Take care to ensure that
the mains cable is not jammed or twist-
ed.
4. Pull the handle to the first (uppermost)
latching position.
5. Close the handle adjustment.
6. Insert the suction hose into the connec-
tion nozzle.
7. Insert the suction pipe into the mount on
the device
Installing the filter bag
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to un-
lock.
3. Insert the filter bag and turn the filter bag
lock to the left to lock.
4. Fit and lock the filter cover.
Connecting the mains power cable
1. Open the cable holder at the handle.
2. Plug the mains cable provided into the
socket on the device.
3. Secure the plug connection against un-
intentional unplugging using the cable
holder on the handle.
Use only the mains cable provided and only
replace it with an equivalent cable in the
case of damage (see "Technical data").
English

Installation

Startup

to the device
13