Designated Use; Product Information; Data Plate - Buderus SM80/5 Notice D'installation Et D'entretien

2.2

Designated use

The DHW tank can be operated in a solar thermal system with a boiler as
a back-up, or for high output only with a boiler. (Operation of the two
heat exchangers in series or parallel.) The tank is designed for heating
and storing drinking water. Please observe national, regional, and local
codes, regulations, guidelines and standards for drinking water. When
operated as part of a solar system, the solar thermal system must be
filled with solar antifreeze to prevent frost damage.
The tank can be used only in closed loop systems and is not suitable for
drain-back solar thermal systems. Any other purpose is considered
improper use. Any resulting damage is excluded from the
manufacturer's warranty.
Requirements
for potable water
Water hardness, min.
pH value, min. – max.
Conductivity, min. – max.
Table 3 Requirements for potable water
2.3

Product Information

Item Description
1 DHW outlet
2 Boiler supply
3 Sensor well for temperature sensor, heat source or
aquastat
4 Recirculation connection
5 Boiler return
6 Solar supply
7 Sensor well for temperature sensor, solar
8 Solar return
9 Cold water inlet
10 Bottom heat exchanger for heating by a solar system,
smooth enameled tubing
11 Inspection port for service and cleaning at the front
12 Fitted magnesium anode without electrical insulation
13 Upper heat exchanger for reheating by heating appliance,
smooth enameled tubing
14 Tank, enameled steel
15 Fitted magnesium anode without electrical insulation
16 PS top cover
17 Jacket, painted sheet metal with rigid polyurethane foam
insulation, 2" (50 mm)
Table 4 Product Information
SM80/5, SM100/5 – 6 720 800 156 (2014/10)
Unit
ppm 36
grain/US gallon 2.1
°dH 2
6.5 – 9.5
μS/cm 130 – 1500
15
14
13
12
11
10
Fig. 2 SM80/5, SM100/5
2.4

Data plate

The data plate is located at the top rear of the DHW tank.
2
Product Information
16 17
1
2
3
4
5
6
7
8
9
6 720 800 155-01.1ITL
5