Operating The Appliance; To Raise The Hood Intake Housing; To Lower The Hood Intake Housing; Over-Temperature Sensor - Thermador Masterpiece Serie Manuel D'utilisation

O P E R A T I N G T H E A P P L I A N C E
Always turn the downdraft blower on before you begin cooking to
establish an air fl ow in the kitchen. Let the blower run for a few minutes
to clean the air after you turn the cooktop off. This will keep the whole
kitchen cleaner and brighter.
It is recommended to use the rear burners when cooking with tall pots
or when the cooking method will generate high amounts of smoke or
steam. The combination of using the rear burners and operating the unit
at high speed will increase the likelihood that all the smoke and steam
will be removed by the downdraft.

To Raise the Hood Intake Housing

Press and release the push button switch.
Note: Press the push button switch once to raise the intake housing. All
previous control functions will be restored.

To Lower the Hood Intake Housing

Press and release the push button switch.
Note: The hood housing can be lowered without setting any controls to
the Off position. All functions will stop and the hood will lower.
If hood intake housing movement stops:
Locate and remove any obstruction. Press the push button switch again
to resume movement.

Over-Temperature Sensor

When the hood detects excessive heat, the auto icon will blink 3 times.
The fan will increase in speed to protect sensitive components. The
lower speeds will light up and cannot be selected until the hood cools
down. Once the hood cools down, the fan will stay on the same speed
with only the icon for that speed illuminated. The hood will resume
normal operation.
Page 8
RAISE/LOWER

Downdraft Hood Control Panel

0 - BLOWER OFF
0
1 - BLOWER LOW
1
2 - BLOWER MEDIUM
2
3 - BLOWER HIGH
3

AUTOMATIC OPERATION

AUTO

10-MINUTE DELAY OFF

DELAY

FILTER CLEAN REMINDER

FILTER
All hood controls, located on the right side panel of the intake housing
frame, are visible when the hood is raised.
Adjust downdraft hood blower speed:
Press and release 0, 1, 2 or 3 on the control panel.
•
0 = Off
•
1 = Low
•
2 = Medium
•
3 = High
Automatic Operation
Press and release AUTO on the control panel to activate the AUTO ON
feature. When the control senses a high level of heat, the fan will turn
on to Medium speed. When the control no longer senses a high level of
heat, the fan will turn off.
10-Minute Delay Off
Touch and release the DELAY icon on the control panel to start a 10-minute
timer that will shut off the fan set at any speed after 10 minutes.
Filter Clean Reminder
After 30 hours of accumulated blower run time, the FILTER icon on the
control panel will begin to blink continously as a reminder to clean the
hood fi lters.
To reset the reminder timer and turn the FILTER icon OFF, touch and
hold the FILTER icon for 2 or more seconds.