Common Ducting Configurations; Choosing The Correct Blower - Thermador Professional VCIN36GWS Instructions D'installation

Common ducting configurations

inches (mm)
Integral blower Integral blower Integral blower
NOTE: The figure does not represent all configurations or
installation methods. The image is to be used as a guide
ONLY.

Choosing the correct blower

Blower motors
All blower models are sold separately. It is recommended
to use only Thermador blowers with Thermador Pro
ventilation hoods. See the "Ventilation Planning Guide"
for recommended blowers. Contact Customer Service for
additional options (see the back page for contact
information).
Varies
12 12 12 "
11/ 16
(326) (326) (326)
Remote blower
In-line blower In-line blower In-line blower
Back-draft Back-draft Back-draft
damper on damper on damper on
transition transition transition
30" (762) –
40" (1,016)
Integral, in-line and remote blowers are available through
your authorized Thermador
information, visit the Find a Dealer section of our website
at www.thermador.com.
The blower performance options will vary in cubic feet per
minute (CFM) and is dictated by the cooking surface, the
volume of air that needs to be moved and the length of
the duct run. For long duct runs with multiple turns and
bends, consider using a more powerful blower. For the
most efficient air-flow exhaust, use a straight run or as few
elbows as possible (refer to "Ductwork Preparation").
Remote
blower
®
dealer. For local dealer
9