KitchenAid KSDB900E Instructions D'installation page 25

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Apply masking tape to the end of a
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
5. Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart
Burner Rating
Color
19,000 BTU (ST)
White/Gray
17,000 BTU (ST)
N/A
17,000 BTU
White/Blue
15,000 BTU
White/Green
9,200 BTU
White/Black
8,000 BTU
White/Yellow
5,000 BTU
White/Orange 1.00
1,200 BTU
Black
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door
for proper sizing of spuds for each burner location.
" (7 mm) nut driver
9
32
D
A
Size (mm) ID Number
1.84
184
1.75
175
1.90
190
1.80
180
1.35
135
1.25
125
100
0.52
52
6. Place LP gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the LP gas orifice spuds in case
of reinstallation with LP gas.
7. Replace the burner base.
8. Replace the burner cap.
9. Repeat steps 1 to 7 for the remaining burners.
Complete Installation (LP Gas to Natural Gas)
1. Refer to the "Make Gas Connection" section for proper
connection of the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition and operation.
3. Refer to the "Adjust Flame Height" section for burner flame
adjustments.
IMPORTANT: You may have to adjust the low setting for
each cooktop burner.
Checking for proper cooktop, bake and broil burner flame
is very important. Natural gas flames do not have yellow tips.
4. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
IMPORTANT: Make sure to save the orifices that have
just been replaced in the conversion.
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kseg950ess

Table des Matières