Rational iCombi Pro Installation page 7

5 | Installation
protect the front panel from tipping
off, mount a nut on the bolt at the
front left.
13. Insert the left side panel. The side
panel runs around the edge up to the
rear side of the frame. Fix the left side
panel on the rear side of the Combi-
Duo frame with 1 screw
[ Figure 10].
14. If an Ethernet cable is to be connected
to the top device, connect the cable
before the exhaust pipe is mounted for
better accessibility.
15. Place the heat shield cover on the bot-
tom part of the exhaust pipe so that
the connections on the rear side of the
top device are protected from heat
[ Figure 11].
16. Place the exhaust pipe on the air vents
of the bottom device [
17. Place the holder on the air vents of the
top device and the exhaust pipe
[ Figure 13].
Turning the door handle of the bottom
device
1. Dismantle the door handle of the bot-
tom device: Remove the plastic cover
of the door lock on the inside of the
door by pushing the cover to the in-
side of the door and remove it.
2. Loosen the screw of the door handle
with a 5 mm Allen key.
3. Pull off the door handle, turn it
180 degrees and mount the door han-
dle again.
4. Mount the plastic cover again.
80.51.373_iCombi Pro-iCombi Classic_CD E_IM_V02_US-nord
Figure 12].
en-US
7 / 20