Preparations; Installation - Rational iCombi Pro Installation

Masquer les pouces Voir aussi pour iCombi Pro:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en-US
5
Water drain
height - bottom
unit
4

Preparations

Setting up the bottom device
In order to set up the bottom device for
the Combi-Duo setup, mount the device
on a stand with feet, guide rollers or on a
leveling kit.
Note that the minimum wall distance for
the Combi-Duo device is 50 mm [2 inch].
For setting up the device on the stand, fol-
low the description in the installation man-
ual for the device.
Bottom device alignment
Align the stand: Set up the device and
n
check the alignment with a spirit level
in the cooking cabinet. If necessary,
align the guide rollers or feet evenly so
that the device is stable.
Aligning the leveling kit: Set up the
n
leveling kit and check the alignment
with a spirit level before positioning
the bottom device on the leveling kit.
5

Installation

Setting up the Combi-Duo and the top
device
a
The bottom device is set up on a stand
with feet or guide rollers or a leveling
kit.
a
The top of the bottom device is clean
and free from grease.
1. Loosen the 5 screws from the cover of
the bottom device.
2. Press 2 metal lugs on the top of the
bottom device on the exhaust cover to
loosen them from the slots and pull
away the cover [
6 / 20
Figure
02].
80.51.373_iCombi Pro-iCombi Classic_CD E_IM_V02_US-nord
3. Place the Combi-Duo base frame on
the bottom device. Align the frame so
that the closed, right side panel of the
frame joins flush with the right device
wall [
Figure
4. Fix the Combi-Duo base frame with
5 screws [
Figure
5. Place the large insulation mat on the
right and the small insulation mat on
the left in the 2 designated gaps in the
Combi-Duo base frame [
6. To secure the insulation mat, press the
insulation mat under the frame at the
edges [
Figure
7. Remove the rubber seal around the
device base edge of the top device.
8. Place the top device onto the Combi-
Duo base frame using lifting straps
[
Figure
07].
9. Position the base of the top device on
the bars of the Combi-Duo base frame.
Take care not to damage the side pan-
els of the base frame.
10. Push the top device from the front left
to the back right into the free corner of
the frame. Ensure that the engaging
edge of the top device engages in the
groove of the frame, at the rear right in
the corner and at the front left in the
corner [
Figure
11. Insert the front panel on the front left
at a slight angle. The top sheet edge of
the front panel can be pushed under-
neath into the housing frame of the
top device.
12. Push the front panel to the right to the
side panel [
Figure
the pin and the edge protruding from
the right side panel fit into the opening
and the groove on the front panel. To
4 | Preparations
03].
04].
Figure
06].
08].
09]. Ensure that
05].

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Icombi classic

Table des Matières