NSK ENDO-MATE AT Mode D'emploi page 6

(4) PROGRAM Key (- +)
Press to select the Program No. from  to 9.
Press (+) or (-) to change the Program No.
While the key is held down, the Program No. changes continuously.
(5) REVERSE Key
Press to select the rotation mode (forward rotation, reverse rotation).
(6) GEAR RATIO Key
Press to select the gear ratio appropriate for the Contra Angle Head in use. (:, 4:, 0:, 6:, 20:)
(7) AUTO REVERSE Key
Press to select the auto reverse mode.
For details, refer to "8-3 AUTO REVERSE Function".
(8) MEMORY Key
Press to memorize the values displayed in the LCD Panel in programs.
For details, refer to "8- Memory Function".
4-2 LCD Panel
(F) ROTATION MODE
(G) AUTO REVERSE
MODE
(H) ALARM SOUND
VOLUME
(A) SPEED
Displays the selected rotation speed.
Depending on the speed,
(B) TORQUE
Displays the selected torque upper limit.
(C) TORQUE BAR GRAPH
The bar graph shows the level of load applied while the Motor Handpiece is rotating.
*The diagram shows the Panel when all the lights are on.
or may also appear.
5
(A) SPEED
(B) TORQUE
(E) GEAR RATIO
(D) PROGRAM No.
(C) TORQUE BAR GRAPH