NSK ENDO-MATE AT Mode D'emploi page 10

NOTICE • This function deletes all the settings stored in the programs and restores the original values
(factory default settings). If necessary, note down the current settings before using this
function.
8-3 AUTO REVERSE Function
While the Motor Handpiece is rotating, the alarm sounds when the torque has reached half of the set upper
level. (At this point, the bar graph looks like this.
When the torque gets close to the specified upper limit, the alarm sound changes.
(At this point, the bar graph looks like this.
If load is applied further and the torque exceeds the set upper limit, the Motor Handpiece starts operating
in the selected Auto Reverse mode. The Auto Reverse mode can be selected from among the three modes
shown below.
AUTO REVERSE
When the torque reaches the set load level, the forward rotation of the Motor Handpiece stops, and the
reverse rotation starts. When load is no longer applied, the forward rotation resumes automatically.
When torque is
within the set
upper limit.
Forward Rotation
AUTO STOP
When the torque reaches the set load level, the forward rotation of the Motor Handpiece stops, and the
reverse rotation starts. When load is no longer applied, the rotation stops. To resume the rotation (forward
rotation), press the ON/OFF Key.
When torque is
within the set
upper limit.
Forward Rotation
AUTO REVERSE OFF
When the torque has reached the set load level, the rotation stops. To resume the rotation (forward rotation),
press the ON/OFF Key.
)
)
When torque exceeds
the set upper limit.
Reverse Rotation
When torque exceeds
the set upper limit.
Reverse Rotation
9
If the load goes on,
reverse rotation carries on.
If the load stops, ...
Forward Rotation
Fig. 5
If the load goes on,
reverse rotation carries on.
If the load stops, ...
Rotation stops
Fig. 6