During Use; After Use - Dräger FPS-COM 7000 Notice D'utilisation

6. Press the push-to-talk button and check that the communication is
functioning.
When using the insert for the Bluetooth connection, wait until the
radio and the communication unit are connected to each other.
If no Bluetooth connection can be established, the insert must be
coupled again to the radio.
7. Switch off the radio and the communication unit.
3.3.2 Coupling (pairing) the insert for the Bluetooth
connection and the radio
The insert for the Bluetooth connection must be fitted.
1. Set the radio to pairing mode.
2. Switch on the Bluetooth pairing mode of the communication unit:
Press the ON/OFF button
simultaneously.
A visual signal indicates that the communication unit and the radio
are being coupled. Functional readiness is then displayed.
3. On the radio select the Bluetooth name if necessary and enter the
activation pin (0000).
The Bluetooth name is the serial number in the factory setting. It
can be modified via the optional configuration software.
When the radio and the communication unit have been successfully
coupled, the communication unit and the radio will only need to be
switched on the next time. They will then be automatically connected.
28
and the push-to-talk button
3.4

During use

CAUTION
!
When using a communication unit with a radio, make sure that
there is no acoustic feedback from a second radio.
Acoustic feedback may cause hearing damage.
NOTICE
i
i
If the Bluetooth connection is interrupted, the communication unit
will automatically attempt to establish this connection again until
the radio is within range again. The voice amplifier unit remains
functioning during this process.
3.4.1 Establishing readiness for use
1. Put on the full face mask. Position the earphone over the nomex
hood and below the protective helmet.
2. Switch on the radio and the communication unit.
3. Check the functioning of the communication unit: The volume of
spoken words must be amplified.
4. Adjust the volume on the radio if necessary.
5. Check that the communication via the radio is working.
3.4.2 Interrupting the automatic shutdown sequence
If the communication unit is not in active use, the "AUTO OFF" warning
signal sounds after approx. 4 minutes. If no further audio signals are
received by the communication unit, it switches itself off after another
minute has passed. It then needs to be switched back on again.
To interrupt the automatic shut-down, send an audio signal to the

communication unit (e.g. speak into the full face mask).
3.5

After use

Clean the communication unit (see chap. 5.2 on page 31).

Dräger FPS-COM 7000