Adjusting The Volume; Preparations Before First Use - Dräger FPS-COM 7000 Notice D'utilisation

3.1.6 Switching on the HazMat mode
If the communication unit should always be operated in HazMat mode,
this can be set in the configuration software.
If the communication unit should only temporarily be operated in
HazMat mode, switch on the HazMat mode as follows:
When the communication unit is switched off, press the ON/OFF

button for approx. 3 seconds.
The communication unit is switched on, however the voice
amplifier unit is deactivated (HazMat mode). An acoustic signal
sounds.
NOTICE
i i
The setting is reset when the communication unit is switched
off. The voice amplifier unit is switched back on again when
the communication unit is switched back on again.
3.1.7

Adjusting the volume

NOTICE
i i
Press and hold down the volume controller for half a second
each time. Simply touching it does not change the setting.
To increase the volume, press the volume controller repeatedly

forward until the desired level is reached.
To reduce the volume, press the volume controller repeatedly

backward until the desired level is reached.
An acoustic signal indicates that the volume has been adjusted.
Another acoustic signal indicates that no further volume level is
available.
26
3.1.8 Selecting another group
NOTICE
i i
Press and hold down the group selector switch for half a
second each time. Simply touching it does not change the
setting.
Press the group selector switch repeatedly until the desired group

is selected.
The respective group is announced.
3.1.9 Configuring the communication unit
1. Fit the insert for the configuration cable.
2. Plug the configuration cable into a USB port on the PC.
3. Start the software on the PC.
An explanation how to operate the software is provided in the help
pages of the software.
3.2

Preparations before first use

1. Fit the suitable insert (see chap. 3.2.1 on page 27).
2. Insert the batteries (see chap. 5.3.1 on page 32).
3. Attach the communication unit to the full face mask (see
chap. 3.2.2 on page 27).
CAUTION
!
During assembly work the specified torques must be
observed since the communication unit could otherwise be
damaged. Use a suitable tool!
Dräger FPS-COM 7000