SoClean 2 Guide D'utilisation page 19

Figure 2. Connect the Injection Fitting
Injection
Injection
Hose A
Fitting
Injection
Hose B
2. Using an adapter
If your PAP machine requires an adapter, see adapter
instructions for set-up and proceed to Step 5.
3. Connect the Injection Fitting
The Injection Fitting connects the SoClean 2 to your PAP
machine. Once installed, you do not need to disconnect
the Injection Fitting to use your PAP. The SoClean 2
is intended to stay continuously connected to your PAP
machine.
Note: Your PAP reservoir model may require additional
configuration procedures or an adapter. If you have
difficulty with the steps in this guide, contact SoClean
customer care.
With humidifier:
1. Position the Injection Fitting onto the port of
your humidifier (where your PAP Hose was
connected), allowing the smaller Injection Hose B
to enter into the reservoir (Figure 2). The end of the
tubing should be positioned over the heat plate.
2. If necessary, carefully trim the Injection Hose B
in increments until it is the correct length, and
over the heat plate.
For additional help in connecting to your specific
machine, please visit our support pages at:
SoClean.com
ENG | 15