Connection Steps - SoClean 2 Guide D'utilisation

CONNECTION STEPS

After following these steps, your SoClean 2 will maintain
your PAP machine daily without disconnecting. Before you
disconnect your PAP machine to wash the parts, look at
where the PAP Hose is connected. You will reconnect the
SoClean Injection Fitting to the same location.
Figure 1. Disassemble and wash PAP equipment
Please note, SoClean devices do not replace proper
cleaning and maintenance of the PAP device
according to the manufacturer's instructions
14 | CONNECTION STEPS
1. Pre-wash PAP equipment
Disconnect your PAP mask, hose and reservoir
from the PAP machine.
Use two capfuls of the included Neutralizing
Pre-wash with 4 litres (1 gallon) of water to wash
your PAP equipment (mask, hose and reservoir),
according to the manufacturer's instructions
(Figure 1).
Rinse thoroughly with clean water.
Reinsert the reservoir (if used) into the PAP machine.
Do not reattach the hose or mask yet.
CAUTION: Do not place Neutralizing Pre-wash in
the SoClean 2 Chamber or PAP reservoir. Neutralizing
Pre-wash is for cleaning your PAP equipment only.
NOTE: Instructions for use will clarify how the SoClean
2 is used, including the requirement to disconnect from
the PAP unit.
1.5 oz