Combustible Finish; Finishing Material - Kozy Heat Fireplaces KZK-1510 Manuel D'installation

Kit komfort zone
Masquer les pouces Voir aussi pour KZK-1510:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.2 Combustible Finish

3.2.1 Finishing Material

NOTE: If you desire to run finishing material up to edge of the discharge
opening, see Figure 3.3 and Figure 3.4 below. Finishing material must
not block the air discharge grille and must be run evenly along the
plenum opening.
WARNING! RISK OF OVERHEATING AND FIRE! Ensure the KZK duct
system is installed in accordance to this manual AND the convection
baffle is removed when using these combustible clearances.
DRYWALL STOPS AT EDGE OF AIR DISCHARGE OPENING.
AIR GRILLE DISCHARGE WILL OVERLAP EDGES OF DRYWALL
¼
10
"
(260mm)
Figure 3.3, #KZK-1510 Drywall Finish
UP TO 1" (25mm) THICK COMBUSTIBLE MATERIAL UP TO EDGE OF
THE AIR DISCHARGE GRILLE. 1" COMBUSTIBLE MATTERIAL CANNOT GO
CLOSER TO DISCHARGE OPENING. 1" COMBUSTIBLE MATERIAL GOES ON TOP
OF ANY REQUIRED NON-COMBUSTIBLE MATERIAL REQUIRED ON THE FIREPLACE
11
"
Figure 3.4, #KZK-1510 Combustible Finishing Material up to 1" Thick
Komfort Zone Kit #KZK-1510
15"
(381mm)
15
"
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
COMBUSTBILE
MATERIAL
UP TO 1" THICK
DISCHARGE GRILLE
11
"
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières