Functions - JUMO iTRON 702040 Notice De Mise En Service

5

Functions

We recommend the following procedure:
h Familiarize yourself with the controller functions
h Enter the configuration codes and the parameter values in the tables provided for this pur-
pose in Chapter 6. Write down the appropriate values (
( ). The parameters and the configuration codes are listed in the order of their
X
appearance. Parameters which are not relevant are masked out (see table below).
h Enter the configuration code and parameters on the instrument
Configuration
Single-setpoint controller
Double-setpoint controller
Limit comparator no function
Limit comparator activated
Resistance thermometer, thermocouple
Ramp function off
Setpoint switching not activated
Timer function: no function
Type 702040/41
1. not for Type 702040/41 with 2 relay outputs (option)
Masking out the parameters for
Double-setpoint controller
Limit comp. for Type 702040/41
Logic input for Type 702040/41
Limit comparator
Logic input for Type 702040/41
Standard signal scaling
Ramp function
Setpoints at the parameter level
Timer function
Output 3
), or mark selection with a cross
Parameter
Pb:2 , Cy 2
C114 HySt
,
1
C117
HySt AL
,
1
C117
SCL , SCH
rASd, SPr
SP 1 , SP 2
t i C121 C122
, ,
C118
, db , HyS.2
AL
,
C123
,
16