Maintenance/Servicing - Hozelock Seringa Mode D'emploi

During use
- Pump a few times to prime the apparatus
(Fig. 12) until spraying starts (Fig. 13), then
pump at a regular rate.
- Adjust the jet (Fig. 14).
After use/ Cleaning
After each use:
- Eliminate any residual pressure that may
remain in the apparatus by spraying until there
is no more pressure.
- Avoid risks of pollution by recovering any
unused product and its packaging.
- Wash your hands and face with clean water
after using the sprayer.
- Never store the sprayer pressurised.
- Never store the treatment agent inside the sprayer.
- Store the sprayer in a closed location out of the
reach of children.
- Before storing and before any other use
with another treatment agent, perform a
rinsing operation, i.e. put 1 litre of water into
the reservoir for dilution, mix thoroughly
and operate the apparatus to rinse all of the
apparatus' components.
This rinsing operation must be carried out
without removing any of the accessories used
during the treatment. The rinsing mixture must
not be emptied into a sewer but must be sprayed
outside on the land that has already been
treated.
- Repeat the operation several times before the
winter period.
- Recover any possible excess of product and
rinse the sprayer again as indicated above.
- Before using again, even if it is used again
immediately, with the same treatment product
or a different one, repeat the rinsing operation
3 consecutive times and check that the sprayer
works properly (especially the safety valve).
MAINTENANCE / SERVICING
Periodically, on re-use after the winter period
and several times per season, grease all the
joints (with silicone grease for sprayers) and
check that the sprayer is working properly.
- Clean the nozzle and the nozzle holder (Fig. 15)
- Clean the strainer filter (Fig. 16).
- Grease with sprayer grease the nozzle gasket
(A), the gasket (B) and the part of the tube (C)
(Fig. 17).
PROBLEMS / SOLUTIONS
Operating errors: (Fig. 17)
- If the lance is only working in one direction,
check that the elements (E), (F) and (G) are
present. If they are missing, replace them.
-If the lance is leaking between the two sliding
parts, check the condition of the scraper gasket
(D) and the gasket (B). Grease and replace if
necessary.
- If the syringe is hard to move: Check that the
filter (E) is not blocked. Clean if necessary.
Check the condition of the scraper gasket
(D) and the gasket (B). Grease and replace if
necessary
WARRANTY
Extended contractual warranty
We guarantee our products for 3 years. The
contractual warranty does not apply in the
following cases:
- Normal wear parts: seals, valves, nozzle, piping.
-The products that are used in violation of the
technical recommendations,
- Products used improperly,
- Products not undergoing regular maintenance,
- Damage to products (impacts, drops, crushing,
etc.) caused due to negligence, improper
maintenance, improper or abnormal use of the
product,
- The replacement of a component after losing a
component of the sprayer.
Warranty activation
Contact your retailer to apply your warranty.
Please keep your proof of purchase (invoice
or legible till receipt), as this will be required
in the event of a claim under the Contractual
Warranty.
A product under warranty that has been
repaired or replaced, remains guaranteed for the
remaining duration and under the original terms
of the Contractual Warranty granted at the time
of purchase.
All returned products become the property of
HOZELOCK when replaced by a new product.
SPECIFIC CASES
Australia:
Our goods come with guarantees that cannot
be excluded under the Australia Consumer Law.
You are entitled to a replacement or refund for a
major failure and for compensation for any other
reasonably foreseeable loss or damage.
9