Installation Instructions; Before Installation; After Installation - Pando PHV9400 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

EN

Installation instructions

Before installation

Check that the input voltage indicated on the
characteristics plate is the same as the 4voltage of
the power outlet you are going to use.
Open the oven door and take out all the
accessories and remove the packing material.
Warning! The front surface of the oven may be
covered in a protective film. Before using the oven
for the first time, carefully remove this film, starting on
the inside.
Make sure that the oven is not damaged in any
way. Check that the oven door closes correctly and
that the interior of the door and the front of the oven
opening are not damaged. If you find any damage
contact our Customer Care Centre on the number
supplied on the back cover of this handbook.
DO NOT USE THE OVEN if the power cable or the
plug is damaged, if the oven does not function
correctly or if it has been damaged or dropped.
Contact our Customer Care Centre on the number
supplied on the back cover of this handbook.
Put the oven on a flat and stable surface. The oven
must not be installed close to any sources of heat,
radios or televisions.
During installation, make sure that the power
cable does not come into contact with any
During installation, follow the instructions supplied separately.
28
moisture or objects with sharp edges and the
back of the oven. High temperatures can damage
the cable.
Warning: after the oven is installed you must
make sure you can access the plug.

After installation

The oven is equipped with a power cable and a plug
for single phase (household) current, 230-240V ~
50Hz.
If the oven is to be installed on a permanent basis
it must be installed by a qualified technician. In such a
case, the oven should be connected to a circuit with
an all-pole circuit breaker with a minimum separation
of 3 mm between contacts.
WARNING: THE OVEN MUST BE EARTHED.
The manufacturer and retailers do not accept
responsibility for any damage that may be caused to
persons, animals or property if these installation
instructions are not observed.
The oven only functions when the door is closed
correctly.
Before the first use, clean the inside of the oven and
the accessories, following the cleaning instructions
given in the "Oven cleaning" section.

Publicité

Table des Matières
loading

Table des Matières