Descaling Procedure - Pando PHV9400 Mode D'emploi

Care and maintenance

Descaling procedure

Warning: For safety reasons, the descaling
process cannot be interrupted and it takes
about 45 minutes.
The appliance can be descaled with the appliance
door open or closed. The appliance must be in
idle state prior to starting the descaling cycle.
To run a descaling cycle proceed as follows:
1. Press the "-"and Clock key for 5 seconds.
The display shows "CAL" and there is an
intermittent beep. If you wish to cancel the
descale process at this stage (just wait for
about 5 seconds without pressing any key
2. Press the "Start" key (3) to start the
descaling function.
3. When the display shows "0.5L", Short beeps
are emitted. Remove the water tank.
4. Pour 0,5 litres of an adequate descaling
solution into the water tank and put the
water tank back.
5. Press the "Start" key (3). The Descale cycle
is initiated and takes about 30 minutes.
6. When the display shows "1.0L" flashing and
the oven emits a beep, remove and empty
the water tank.
7. Fill the water tank with 1,0 litres of cold
water and put the water tank back.
8. Press the "Start" key (3). The first rinsing
cycle starts.
9. When the display again shows "1.0L"
flashing and the oven emits a new beep,
remove and empty the water tank.
10. Fill the water tank with 1.0 litres of cold water
)
.
and put the water tank back.
11. Press the "Start" key (3). The second rinsing
cycle starts.
12. When the rinsing cycle has finished the
display shows "End". The message "DEP"
will be displayed until the water tank is
removed.
13. Remove, empty and dry the water tank.
EN
23