Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Oil Warmer
1. Drain oil from engine as described in Maintenance in
operator's manual.
2. Position rags to collect residual oil from crankcase.
Remove crankcase block plug (B) from engine and
discard plug.
NOTICE Illustrations are representative. Installed parts may
look different from those shown.
B
3. Hand thread oil warmer into engine block. Do not use
thread sealant or teflon tape as oil warmer is coated
with sealant.
4. Using 11/16 in. wrench, tighten oil warmer 1/4 turn
past snug.
For vertical shaft engine, use crowfoot
wrench to tighten oil warmer 1/4 turn
past snug.
5. If secured, remove tie wrap securing wiring harness
2 pin connector labeled "240 Volts".
6. Connect oil warmer 2 pin connector into wiring
harness 2 pin connector. On vertical shaft units, make
sure wiring harness connection does not interfere with
oil drain hose.
7. Fill engine with recommended oil following
oil fill instructions given in Maintenance in
operator's manual.
NOTICE Any attempt to crank or start the engine before it
has been properly serviced with the recommended oil will
result in equipment failure.
• Refer to Maintenance in operator's manual for oil
fill information.
• Damage to equipment resulting from failure to follow this
instruction will void engine and generator warranty.
8. Inspect for oil leaks in area around oil warmer.
Restore Power and Test Unit
1. After all servicing has been completed, replace fuses
in transfer switch, replace 15 Amp fuse in control
panel, set system switch and circuit breaker ON and
reset exercise timer. See Setting Exercise Timer.
2. Manually start generator and inspect for oil leaks in
area around oil warmer. Turn off engine, allow unit to
cool, and repair any observed leaks.
3. For vertical shaft units, reassemble unit panels
in reverse order of disassembly. Do not exceed
15-35 in/lb (17-40 Newton/meter) torque on
all fasteners.
For horizontal shaft units, reinstall or close door(s).
This completes installation of the oil warmer accessory.
Should any questions arise during this procedure, call
Technical Support at (800) 743-4115 weekdays between
8:00 AM and 5:00 PM CT.
3
Publicité
Table des Matières
