Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Disconnect Power
1. Set generator's circuit breaker to its OFF position.
2. Set control panel system switch to OFF.
3. Remove 15 Amp fuse from control panel.
4. Utility voltage is present at generator control panel.
Disconnect power before servicing control panel by
removing the fuses from the transfer switch.
CAUTION With the system switch set to AUTO, the
engine could crank and start at any time without
warning, resulting in minor or moderate injury.
• To prevent possible injury that may be caused by such
sudden starts, always set the system switch to OFF if
performing maintenance on the system.
• Remove the 15 Amp fuse before working on or around
the generator or transfer switch.
Vertical Shaft Engines
A
A
Disassembly
Access Panels
To gain access to the generator's control panel, battery, and
oil warmer installation location, open or remove all access
doors as described in generator operator's manual.
Oil Warmer Installation Location
Compare engine on generator with the illustrations below to
determine the oil warmer location (A).
Horizontal Shaft Engines
A
A
2
Publicité
Table des Matières
