salmson SC-Fire Diesel Manuel D'installation Et Mise En Service page 34

English
Captions
Fig. 1 Switchgear set-up
1 Main switch: for switching the switchgear on/
off
2 Menu selection and parameter input
3 Chargers for automatic charging of the starter
batteries
4 Base board: printed circuit board with micro-
controller
5 Converter board
6 Contactors/relay for connecting the starter
and magnetic switch
7 Fusible cut-outs
** Note regarding the main switch:
Power supply for the sprinkler pump motor.
DO NOT SWITCH OFF IN THE EVENT OF A FIRE!
Fig. 2 Switchgear display elements
1 LED (green): Operational standby
2 LED (green): Pump operation
3 LED (yellow): Automatic mode
4 LED (yellow): Excess motor temperature
(cooling water)
5 LED (yellow): Oil pressure fault
6 LED (yellow): False start
7 LED (white): Sprinkler request
8 LED (white): Float switch request
(pump priming tank)
9 LED (yellow): Heating fault
10 LED (yellow): Belt break
11 LED (yellow): Lack of fuel
12 LED (yellow): Collective fault
13 LED (yellow) and button: Test device for
manual starter device
14 LED (red) and button: Manual pump stop
15 Button: Lamp test
16 Button: Manual start of battery A
17 Button: Manual start of battery B
18 Button: Acknowledgement of error messages
34 Wilo Salmson France SAS 01/2014