Display Indications And Symbols - VOLTCRAFT VC250 Notice D'emploi

Display indications and symbols

The symbol and indications are different depending on the model. This is a summary of all possible
symbols and indications for the VC200 series.
Autorange/AUTO
Connect terminal
H
OL or 1.
AC
DC
mV
V
A
mA
µA
Hz
kHz
MHz
Ω
kΩ
MΩ
nF
µF
36
Delta symbol for relative value measuring (= reference value measuring)
stands for "automatic measurement range selection"
Graphic notice to select the required measuring sockets
Data-Hold function is active
Overload = the measuring range was exceeded
Symbol for the operation switch. Pressed in is switched on.
Battery replacement symbol; please replace the batteries immediately to avoid
measuring errors!
Symbol for the diode test
Symbol for the acoustic continuity tester
Alternating current for voltage and current
Direct current for voltage and current
Millivolt (exp.-3)
Volt (unit of electric potential difference or voltage)
Ampere (unit of electric current)
Milliampere (exp.–3)
Microampere (exp.–6)
Hertz (unit of frequency)
Kilohertz (exp.3)
Megahertz (exp.6)
Ohm (unit of electric resistance)
Kiloohm (exp.3)
Megaohm (exp.6)
Nanofarad (unit of electric capacity, exp.-9, symbol
Microfarad (exp.-6)
Symbol for the diode test
Lightning symbol appears in the voltage measurement range 600 V
)