Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
bin or loading door open safety function
As a safety precaution, if the bin or loading door is opened during shredding, the shredder will stop
and the bin full indicator will illuminate (
intelligent help
1
In the unlikely event of the shredder jamming, the Stack and Shred 300X and 300M will stop
shredding, and the jam icon will blink in orange.
2
The shredder will illuminate the FWD (
to clear the jam.
3
If the jam cannot be intelligentally cleared, the jam icon (
open the auto feed chamber to clear any jammed material.
automatic jam clearance
Intelligent Jam Clearance: In the unlikely event of the shredder jamming, the Stack and Shred 300X
and 300M will automatically reverse and forward the engine three times to clear a jam. During this
operation the Paper Jam indicator will flash (
1. operation
1
Unpack the product.
2
Connect the shredder to mains supply.
3
Ensure the ON/OFF button on the back of the machine is in the ON position, which will
illuminate the blue standby symbol (
4
To commence shredding, press the Auto button (
You are now ready to shred.
5
To load the shredder, simply lift the loading door handle to open the loading door and insert
documents. You can open the door further to 90 degrees for easier access if required Load up
to 300 sheets at a time into the feed chamber. Do not fill above the 300 MAX level, this could
damage the shredder.
6
The shredder will start the shredding cycle automatically ONLY after closing the loading door.
If there is still paper in the Autofeed chamber after first attempt, open and re-close the paper
loading door a second time.
Attention: If required you can now lock the loading door by entering a 4 digit code (see Locking
the Paper Loading Door section).
7
If you only have up to 8 sheets to shred, you can use the manual feed slot, provided the auto
feed chamber is empty.
8
Insert paper to be shredded into the feed area. The shredder will detect the paper and start
automatically.
9
If the shredder is left in auto mode for more than 2 minutes without being used, the shredder will
automatically turn back to sleep mode in order to save power.
10
The shredder will automatically 'wake up' from sleep mode when paper is inserted into the
shred mouth or you open the loading door. There is no need to press the Auto button (
).
) and REV (
) buttons in the sequence necessary
) will illuminate in red. At this point
).
).
), which sets the shredder into auto mode.
S T A C K - A N D - S H R E D 3 0 0 X & 3 0 0 M
English
).
9
S H R E D D E R S
™
Publicité
Table des Matières
