Swingline STACK-AND-SHRED 300X Mode D'emploi page 12

English
8. maintenance
The rollers on the auto-feed mechanism may become dirty over time, please wipe clean with a
dry cloth to maintain maximum product performance.
The auto-start infra-red sensor, located in the paper feed entry-slot, can occasionally become
covered in paper-dust causing the shredder to run despite no paper being fed into the machine.
Switch the shredder off at the rear of the machine and carefully clean the sensor using a
cotton-swab.
service
We recommend these machines are serviced every 6 to 12 months by a Swingline service
engineer – see back of this booklet for the contact details of your local service centre and for
enquiries about maintenance contracts.
shredder accessories
We recommend that a paper waste sack for
recycling shredded paper is used on all models.
FCC CLASS B NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CANADA CLASS B NOTICE
This Class B digital apparatus complies with Canadian ICES-003
MODIFICATIONS
Any modifications made to this device may void the authority granted to the user by the FCC and/or by Industry Canada to operate this equipment.
ACCO is a registered trademark of ACCO Brands.
Copyright © 2013 ACCO Brands. All rights reserved.
Issue August 2013
Fusion is a registered trademark of ACCO Brands.
12
register this product online at www.accobrands.com
Accessory Part Number
Recycling Waste 1765029
Sack
Plastic Waste 1765010
Sack
Box Quantity
20
100