Playing Back Tapes; Playing Back A Tape - JVC UX-H33 Manuel D'instructions

Playing Back Tapes

You can play back type I tapes.

Playing Back a Tape

1 Press ) for cassette deck on the unit.
The cassette holder opens.
2
Put a cassette in with the exposed part
of the tape down.
3
Close the cassette holder cover gently.
4
Press 2 3 TAPE.
The unit automatically turns on and
the tape starts playing. The tape
direction indicator (3 or 2) flashes
slowly on the display.
• Each time you press the button, the tape
direction changes:
3 : plays the front side.
2 : plays the reverse side.
When the tape plays to the end, the deck
automatically stops if the Reverse Mode is set to
or . (See "To play both sides—Reverse
Mode.")
19
If no cassette is inserted when you press
2 3 TAPE
"NO TAPE" appears on the display.
To stop playing, press 7.
To fast-wind to the left or to the
right, press ¢ or 4 while the
tape is not running.
The tape direction indicator (3 or 2)
starts flashing rapidly on the display.
To remove the cassette, press ) on
the unit.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape,
both sides once, or both sides continuously.
On the remote control ONLY:
Press REV.MODE (reverse mode).
• Each time you press the button, the
Reverse Mode changes as follows:
: The deck automatically stops after playing
both sides of the tape. Stops when playback
in the 2 direction is finished.
: The deck continues to play both sides of the
tape until 7 is pressed.
: The deck automatically stops after playing
one side of the tape.
The use of C-120 or thinner tape is not
TAPE
recommended, since characteristic
deterioration may occur and this tape easily
jams in the pinch-rollers and the capstans.
REV.MODE