JVC UX-H33 Manuel D'instructions page 133

4
Select the timer (Daily
Timer or Recording Timer)
with the source to play.
On the remote control:
Press UP or DOWN to
select the timer, then press
CLOCK/TIMER.
On the unit:
Press ¢ or 4 to select the
timer, then press TIMER/SNOOZE.
• Each time you press
(¢) or DOWN (4), the
timer mode and the source
change as follows:
TUNER
TAPE
TUNER : tunes in to the last station you were
listening to. (Daily Timer)
REC TUNER : records the last station you were
listening to. (Recording Timer)
• Put a recordable cassette into the deck.
CD : plays a disc. (Daily Timer)
• Load a disc.
TAPE : plays a tape. (Daily Timer)
• Make sure that the tape is in the cassette
deck.
• Make sure that the tape direction is
correct.
The unit enters the volume level setting mode.
5
Select the volume level.
On the remote control:
Press UP or DOWN to set the volume level,
then press CLOCK/TIMER.
On the unit:
Press ¢ or 4 to set the volume level, then
press TIMER/SNOOZE.
• You can select the volume level
("VOLUME – –" and "VOLUME 0" to
"VOLUME 40").
If you select "VOLUME – –," the volume is set
to the previous level when the unit was turned
off.
• To turn off the volume while the Recording
REC
Timer ( TUNER) is working, set the volume
level "VOLUME 0."
The unit enters the clock setting mode.
23
UP
DOWN
CLOCK
/ TIMER
UP
TIMER/SNOOZE
REC
TUNER
CD
6
Adjust the clock if you need.
• See "Setting the Clock" on page 10.
7
Press STANDBY/ON
(or on the unit) to turn
off the unit (standby) if you
have set the timer with the
unit turned on.
• When the timer turns on the unit, the
indicator starts flashing. (If the Recording Timer
is selected in step 4 , the REC indicator also
starts flashing.)
To deactivate the timer temporarily,
press and hold CLOCK/TIMER (or
TIMER/SNOOZE on the unit) until
(timer) indicator on the display
the
goes off.
To activate or change the timer
(with the previous setting), follow
steps 1 to 7 on pages 22 and 23.
• If you want to change the timer setting after the
Daily Timer be used, first deactivate the timer.
• If the unit is turned on when the timer on-time comes
Timer does not work.
• When you unplug the power cord or if a power failure
occurs
The timer will be canceled. You need to set the clock first,
then the timer again.
STANDBY/ON
(timer)
CLOCK
/ TIMER
TIMER/SNOOZE