Publicité
Les langues disponibles
Les langues disponibles
P80140125K 091205
9/12/05
WARNINGS INFORMATION
• DO NOT ALLOW CHILDREN TO OPERATE BBQ.
• ACCESSIBLE PARTS MAY BE VERY HOT, KEEP
CHILDREN AWAY.
• ANY MODIFICATION OF THIS BBQ MAY BE
DANGEROUS.
• DO NOT MOVE THIS BBQ DURING USE.
• TURN OFF THE GAS SUPPLY AT THE GAS
CYLINDER AFTER USE.
• READ THE INSTRUCTIONS BEFORE USING
THE BBQ.
• PARTS SEALED BY THE MANUFACTURER OR
THEIR AGENT MUST NOT BE MANIPULATED
BY THE USER.
• MINIMUM CLEARANCES FROM
COMBUSTIBLE MATERIALS MUST BE:
REAR - 450 mm
SIDES - 250 mm
TOP - 1000 mm
• THIS BBQ IS ONLY TO BE USED OUTDOORS.
• BBQ SPECIFICATIONS CAN BE FOUND ON
THE DATA LABEL ATTACHED ON THE SIDE
PANEL OF THE BBQ TROLLEY.
• DIMENSIONS mm:
3B H 1115 (1565) W 1310 D 625 (700)
4B H 1115 (1565) W 1470 D 625 (700)
• DO NOT STORE OR USE PETROL OR OTHER
FLAMMABLE VAPOURS AND LIQUIDS NEAR
BBQ.
• DO NOT STORE EMPTY OR FULL SPARE GAS
CYLINDERS UNDER OR NEAR BBQ.
• KEEP THE GAS HOSE AND ANY ELECTRICAL
CORD AWAY FROM HOT SURFACES.
• AVOID UNNECESSARY TWISTING OF HOSE.
• VISUALLY INSPECT HOSE PRIOR TO EACH USE
FOR CUTS, CRACKS, EXCESSIVE WEAR OR
OTHER DAMAGE.
• THE HOSE MUST BE REPLACED IF
DAMAGED AND WHEN NATIONAL
CONDITIONS REQUIRE IT.
• NEVER LIGHT BBQ WITH HOOD CLOSED.
• NEVER LEAN OVER COOKING SURFACE WHILE
LIGHTING BBQ.
• USE BBQ TOOLS WITH WOOD HANDLES OR
GOOD QUALITY INSULATED OVEN MITTS
WHEN OPERATING BBQ.
• NEVER ALTER OR MODIFY THE REGULATOR
OR GAS SUPPLY ASSEMBLY.
SAFETY INFORMATION
• Never operate this BBQ without a regulator.
• Depending on which gas you decide to use, you
will need to approach your local gas dealer for a
regulator. Following supply pressures are a guide
only:
For
:
NL
}
Butane - 30 millibars
Propane - 30 millibars
For
GB
IE
BE
FR
ES LU CH
}
Butane - 28 millibars
Propane - 37 millibars
1:25 PM
Page 12
The regulator and hose assembly:
• Must be suitable for liquified petroleum gas (LPG).
• Must withstand the above pressures.
• Must not exceed 1.0 metre in length.
• The BBQ is supplied with a loose elbow adaptor
that is suitable for direct conection of a flexible
hose.
• Use appropriate Jubilee clip or twin-eared fastener
to connect hose to BBQ adaptor to secure the
hose/regulator connection.
• After the assembly has been secured, turn on the
gas and check for leaks. See Checking For Gas
Leaks. Ensure this procedure is carried out in a
flame free atmosphere.
• Input
Main burner
3B 15 kW - 1090 g / hr
4B 19 kW - 1380 g / hr
GENERAL INFORMATION
LOCATION OF YOUR BBQ
• Not to be used in garages, porches, breezeways,
sheds or other enclosed areas.
• Not to be used on recreational vehicles.
• Do not obstruct the flow of combustion and
ventilation air around the BBQ.
CHECKING FOR GAS LEAKS
NOTE: Never test for leaks with an open flame.
If you smell gas, turn off at source.
Prior to first use, and at the beginning of each new
season (or, whenever gas cylinder is changed), it is
a must for you to check for gas leaks.
1. Make soap solution of one part liquid detergent
and one part water.
2. Turn burner control(s) to 'OFF', then turn on gas
at source.
3. Apply the soap solution to all gas connections.
Bubbles will appear in the soap solution if
connections are not properly sealed. Tighten or
repair as necessary.
4. If you have a gas leak you cannot rectify, turn off
the gas at the source, disconnect hose and
immediately call your BBQ dealer or supplier for
assistance.
GAS CONNECTIONS
Use gas regulator and hose complying with local
regulations.
GAS CYLINDER SAFETY
• Never store gas cylinder indoors.
• Keep gas cylinder in an upright position.
• Close cylinder valve when BBQ is not in use.
• Do not subject gas cylinder to excessive heat.
• Exchange cylinder away from any ignition source.
BUTANE OR PROPANE?
There are two different types of gas that can be used
I 3B/P (30)
on your gas BBQ. It is important that you use the
correct regulator for the types of gas you buy.
:
The following gas cylinder sizes are recommended:
Butane: > 7 kg. Propane: > 6 kg.
I 3+ (28 - 30/37)
IE
GB
INJECTOR
•Main
•Side burner
Side burner
4.2 kW - 305 g / hr
MAINTENANCE
FLASH-BACK
• Turn off gas at its source and turn the burner
control(s) to 'OFF'. Wait until cooled, then clean
burner tubes and burner ports.
CLEANING THE GRILLPLATES
• Allow to cool before washing in a warm soapy
solution. Use a wash cloth, a vegetable brush, or
steel wool.
CLEANING THE FLAMETAMER
• Periodically wash in a warm soapy solution.
Use a wire brush to remove stubborn burnt on
cooking residue if necessary. Dry thoroughly
before re-installing in the BBQ body.
CLEANING THE GREASE RECEPTACLE
• Allow contents to cool before emptying and
washing in liquid detergent.
ANNUAL CLEANING OF BBQ
Burning-off the grillplate after each use will keep it
ready for instant use. Once a year, give the entire
BBQ a thorough cleaning.
INTERIOR:
• Turn the burner controls to 'OFF' position and
disconnect gas supply.
• Detach the hose/regulator assembly from BBQ.
• Remove and clean the cooking plates,
flametamers and burners.
• Cover gas valve orifices with aluminium foil.
• Brush the inside and bottom of the BBQ body with
a stiff wire brush. Wash with a mild soap and
warm water solution. Rinse thoroughly and dry.
• Remove aluminium foil from orifices and check
for obstruction.
• Check spark electrode, adjusting if necessary.
• Replace burners and adjust spark electrode
collector box.
• Replace other components.
• Reconnect to gas and light test.
• Proper care and maintenance will keep BBQ in top
operating condition and prolong life.
12
Main burner
Side burner
1.15 mm - I 3+ (28-30/37)
- I 3B/P (30)
1.00 mm - I 3+ (28-30/37)
Publicité
