Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Perfect Spray 800 spray attachment
Read the operating instructions carefully beforeusing the tool and observe the safety
instructions. Keep the operating instructions in a safe place.
The Perfect Spray 800 spray attachment was developed for applying water-soluble
paints and lacquers as well as paints and lacquers containing solvents.
1)
Gun body
3)
Nozzle seal
5)
Air cap
7)
Material quantity regulation
9)
Container seal
11)
Container
13)
Valve cover
15)
O-ring
Preparation of the Coating Material
The Perfect Spray 800 spray attachment can be used to spray paints, varnishes and glazes
that are undiluted or slightly diluted. Detailed information is available in the technical
data sheet of the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils,
disinfection agents, plant protective agents
Paints containing solvents and water-soluble
paints, primers, vehicle coating paints,
thick-film glazes
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
Assembly (fig. 1)
You cannot combine different-coloured parts of other attachments. The parts could be
damaged. Slide the nozzle seal (Item 3) with the groove (slot) facing forwards into the
nozzle. Put the nozzle onto the gun body and find the correct position by turning it. Put
the air cap onto the nozzle and tighten it using the union nut. The device may only be
used with seals in perfect condition.
Aligning suction tube (refer to the instructions of the basic device)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
General instruction
Description (Fig. 1)
Thinning recommendation
2)
Needle
4)
Nozzle
6)
Union nut
8)
Trigger guard
10)
Feed tube
12)
Ventilating hose
14)
Diaphragm
undiluted
undiluted
dilute by 5 - 10%
GB
5
Publicité
Table des Matières
