Staufenbiel HSF0314076 Instructions De Montage page 19

THE FUSELAGE
Prepare the two fuselage servos for
installation like shown in the picture.
Drill the screw holes.
Install the servo like shown in the
picture and screw the self tapping
screws.
Make a mark for the screw holes of
the V-Tail and drill them open with a
3 mm drill. The V-Tail needs to have
the same angle like in the mounted
situation when drilling. Afterwards
mount the V-Tail to the fuselage.
Take care not to push the screws
through the wood of the V-Tail. The
screws need to go smoothly through
it without adding force. If they don't,
take the drill and drill the holes
again.
Clip in the clevises of the pushrods
into the horn of the V-Tail halfs.
EN
19