Staufenbiel HSF0314076 Instructions De Montage page 15

EN
Drill a vertical hole into the aileron
for the aileron horn and glue in the
horn with epoxy glue like shown in
the picture.
Prepare a pushrod with the needed
length and clip in the clevis in the
servo horn and the aileron horn.
Beforehand bring the Aileron into
neutral position as well as the servo
in electronical midle position.
Prepare the same things for the flap
as done for the aileron.
Due to the fact that the flaps will
get a crosslink pushrod through the
wing, it is necessary to widen the
outlet with a needle file like shown in
the picture.
15