Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section 2
MOUNTING
Parts
! Caution
The AuCS®-SO may be mounted to the bin or
dispenser only when permitted by local electrical
codes.
Mounting to Bin or Dispenser
NOTE: The ice machine's serviceability may be reduced
when the AuCS®-SO is mounted to the bin or dispenser.
Wall mounting is recommended.
1. Set the mounting bracket over the bin top rail at
desired location.
2. Remove the backing from the foam adhesive tape.
Apply tape to mounting bracket, and along the entire
bin rail.
3. Align the AuCS®-SO key slots with the mounting
bracket tabs. Verify the tabs are at the top of the key
slots and that the AuCS®-SO is level.
Part Number 000007647 06/11
1/2" PVC CONDUIT
FITTING
HOSE CLAMPS
LOCKNUT
BUMPER
FOAM TAPE
BRACKET
4. Remove the backing from the adhesive bumpers.
Attach bumpers to the mounting bracket directly
above the AuCS®-SO control box. This eliminates
upward movement and stops the tabs from
disengaging the key slots.
Mounting
Bracket
Bumper
Mounting to Ice Machine
Mounting to Wall
The AuCS®-SO is mounted to the wall using the two key
slots in the back wall of the accessory. Screw fasteners
(not supplied) must hold the entire weight of the
AuCS®-SO (approximately 10 lbs. [4.5 kg]).
Key Slot Dimensions
Installation Instructions
Gasket
6.56 in.
(16.6 cm)
7
Publicité
Table des Matières
