Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section 3
Automatic Operation
The following occurs when the toggle switch is in the ICE
position:
•
The ice machine control board counts the number of
harvest cycles.
•
The AuCS® accessory interrupts the ice making
mode and starts the clean sequence when the
harvest count equals the "Frequency of Cleaning"
setting of the AuCS®.
•
When the clean sequence is complete
(approximately 30 minutes), ice making resumes
automatically, and the "Harvest Count" is reset to
zero.
Important
Opening the curtain switch will interrupt the clean
sequence. The sequence will resume from the point
of interruption when the curtain re-closes.
NOTE: The harvest count is automatically reset after the
AuCS® sequence is completed. It cannot be reset by
unplugging the modular wire, changing the switch
position, power loss, etc.
Important
Using the AuCS® accessory is supplemental to
regular cleaning and sanitizing. The AuCS®
accessory will clean surfaces that come in contact
with
the
water
distribution
maintenance must be performed every six months
that includes sanitizing the bin (or dispenser) and
adjacent surface areas, which cannot be contacted
by the water distribution system. Refer to the ice
machine installation use and care manual for
cleaning/sanitizing procedures.
Part Number 000007647 06/11
system.
Periodic
Manual Start Operation
Step 1 Set the toggle switch to the OFF position after
ice falls from the evaporator at the end of a Harvest
cycle. Or, set the switch to the OFF position and allow
the ice to melt off the evaporator.
! Caution
Never use anything to force ice from the evaporator.
Damage may result.
Step 2 To start the automatic cleaning system, move
the toggle switch to the CLEAN position. The water will
flow through the water dump valve and down the drain.
The clean light will turn on to indicate the ice machine is
in Clean Mode.
The AuCS® pump energizes automatically to add
cleaner or sanitizer to the ice machine.
Step 3 The ice machine will automatically time out a
ten minute wash cycle, followed by six rinse cycles, de-
energize the clean light and stop. This entire cycle lasts
approximately 30 minutes.
Step 4 After the clean sequence is finished, move the
toggle switch to the ICE position.
Step 5 The ice machine may be set to start and finish a
clean sequence, then automatically start ice making
again.
You must wait about one minute into the cleaning cycle
(until water starts to flow over the evaporator), then
move the toggle switch from CLEAN to ICE position.
When the clean sequence is complete, the ice making
sequence will start automatically.
Operation
13
Publicité
Table des Matières
