Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
General
These instructions are provided to assist the qualified
installer. Check your local Yellow Pages for the name of
the nearest Manitowoc distributor, or call Manitowoc
Foodservice for information regarding start-up services.
Please contact you local Manitowoc Distributor or call
Manitowoc Foodservice for assistance if you encounter
a problem that is not covered by this manual.
Important
Failure to follow these installation guidelines may
affect warranty coverage. Improper installation will
affect dispensing rate. Install only within the
parameters outlined in this installation manual.
Electrical Service
GENERAL
!
A trained and qualified technician must install the
AuCS®-SI or AuCS®-SO.
AuCS®-SI
Line voltage is obtained from the ice machine. Refer to
the Model/Serial plate on the ice machine and
AuCS®-SI to verify both voltages are the same.
AuCS®-SO
Line voltage is obtained from the ice machine or an
electrical outlet. Verify the ice machine voltage matches
the AuCS®-SO or a receptacle with the correct voltage
is available at the AuCS®-SO mounting location.
Voltage Phase Cycle
115/1/60
208-230/1/50/60
4
Installation Instructions
Warning
Amperage
0.3
0.1
Section 2
AuCS®-SI Installation
1. Disconnect power to ice machine at the electrical
disconnect.
Disconnect power to ice machine at the electrical
disconnect. Moving the ice machine toggle switch to
the off position does not disconnect line voltage.
2. Remove right front door.
3. Remove the water trough.
4. Locate the water inlet tube on the right hand side
(see below) of the ice machine base. Directly to the
left of the tube there is a small plug that must be
removed. Press up on the plug until it is out.
Press up on
bottom of plug
to pop out
5. Locate the plug and remove it from the ice machine.
6. Install Y connector through the hole in the ice
machine base. Connect the clear vinyl tubing to one
side of the Y branch, the other side is for the plug
removed in step 5.
!
Warning
Water Inlet
Plug Location
Tubing
Part Number 000007647 06/11
Publicité
Table des Matières
