Maintenance Operations Admissible To The User; Remote Control Battery Replacement; Install The Remote Control Support - Nice Mhouse SL1S Instructions D'installation Et D'utilisation

05. To reset the automation turn the key clockwise and at the
same time move the gate until you hear the carriage .
06. Remove the key and close the release cap cover by turning it
clockwise.
49
11.4 – Maintenance operations admissible to the
user
The list of operations to be regularly carried out by the user is
listed below.
• For cleaning the surfaces of the devices, use a slightly
damp (not wet) cloth. Never use substances containing
alcohol, benzene, diluents or other flammable substances.
Use of these substances may damage the devices and
cause fires or electric shocks.
• Disconnect the automation from the power supply before
removing leaves or stones to stop anyone activating the
door.
11.5 – Remote control battery replacement (fig. 50)
When the battery charge is low, the transmitter range is reduced
significantly.When a key is pressed, if led L1 illuminates and then
immediately fades and turns off, this means that the battery is
completely discharged and must be replaced immediately.
Otherwise if led L1 illuminates briefly, this means that the battery
charge is low; in this case press and hold the key for at least half
a second to enable the transmitter to attempt delivery of the com-
mand. In any event, if the battery charge is too low to complete
a command (and wait for a response) led L1 fades and the trans-
mitter turns off. In these cases, to restore normal operation of the
transmitter, replace the old battery with a new version of the same
type, taking care to observe the specified polarity. To replace the
battery, proceed as shown in fig. 50.
30
50
The batteries contain pollutant substances: do not dispose of
them with normal waste material; follow the instructions fore-
.
seen by local regulations
11.6 – Installing the remote control support
To install the remote control support, see fig. 51.
51