Exhaust High / Low / Off; Surface Light / On / Off; Setting Defrost By Weight; Setting Defrost By Time - Blomberg BOTR30200CSS Mode D'emploi

Masquer les pouces Voir aussi pour BOTR30200CSS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation
3
C
The Ready Set function cannot be
set when using the Defrost (by
weight) feature.

3.3.12 Exhaust High / Low / Off

The exhaust ventilation moves steam and other
cooking vapors from the cooking surface of the
range below the microwave oven.
To operate the exhaust vent, Touch the vent
fan High/Low/Off pad once for the highest
speed setting. Touch the pad again to choose the
Low speed setting and a 3rd time to turn the ex-
haust ventilation off.
If the temperature gets too hot
around the microwave oven, the fan
in the exhaust vent hood will auto-
C
matically turn on at the LOW setting
to cool the oven. The will automati-
cally turn off when the internal parts
are cool. When this occurs, the vent
cannot be turned off.

3.3.13 Surface Light / On / Off

Touch the Light/On/Off pad once for a cook-
ing surface light. Press the pad again to turn the
light off.

3.3.14 Setting Defrost by Weight

Example: To defrost 1lb. of food with the de-
fault power level and cook time determined auto-
matically:
1. Press Defrost Weight pad once. 0.0 will
appear in the display.
2. Use the numeric pads to input weight of food to
defrost in pounds (10 = 1lb.) You may enter any
weight from 0.1 to 6.0lbs Use the numeric pads
to input weight of food to defrost in pounds (10
= 1lb.) You may enter any weight from 0.1 to
6.0lbs.t
3. Press START/+30sec. pad.
When defrosting has finished you will hear beeps.
Over The Range Convection Microwave Oven / User Manual
C
The weight amount must be a valid
entry for this feature to start. A valid
weight entry is 0.1 to 6.0 pounds.

3.3.15 Setting Defrost by Time

Example: to defrost food with the default 30%
power level for 5 minutes:
1. Press Defrost Time pad. 0:00 will appear
in the display.
2. Use the number pads to enter desired defrost
time (defrost time may be set up to 99 minutes
and 99 seconds).
3. Press START/+30sec. pad.
When heating has finished you will hear beeps.
Power levels cannot be changed for
C
both defrost (by weight) or defrost
(by time) because the defrost per-
formance will be adversely affected.
3.3.16 Special notes for
defrosting by time
• After pressing START key, the display will
count down remaining defrost time. The oven
will beep twice during the defrost cycle. At this
time open the door and turn the food if needed
and remove any portions that have already
thawed. Touch the START key to resume the
defrost cycle.
• When heating has finished you will hear beeps.

3.3.17 Defrosting tips

• When using the defrost weight feature, the
weight entered should always be pounds (valid
entries are from 0.1 to 6.0 pounds).
19 / 37 EN

Publicité

Chapitres

Table des Matières

Dépannage

loading

Table des Matières