GRIDDLE MODULE
Clean the griddle shortly after removing food and the griddle has
cooled down.
Cleaning Method:
Hot, soapy water and/or nylon scrub pad
After cleaning dry surface with a paper towel
Drip Tray and Area Under Tray
Allow cooktop to cool completely before cleaning.
Cleaning Method:
Warm, soapy water or nonabrasive cleanser.
Damp cloth or nonabrasive pad.
Dry completely before placing drip tray in position.
GRILL MODULE
For more information, see "Grill" section.
Do not use oven cleaners, metal brushes, abrasive scouring pads
or other scrubbers made to clean outdoor grills.
Cleaning Method:
Grill Grate
Do not clean grill grate in dishwasher.
Do not clean in a self-cleaning oven.
Clean the grill grate shortly after cooking is completed and
the burner has been turned off.
While still warm, use a soft bristle barbecue brush to scrub
the grill grate. Oven mitts may be worn while cleaning.
For thorough cleaning of the grill grate, soak in warm, soapy
water for 30 minutes. After soaking, scrub with nonabrasive
pad.
Wave Tray and Wave Plate
Soak in warm, soapy water to loosen soil. After soaking,
scrub with a nonabrasive pad.
Oven cleaner.
Burner Assembly
Do not soak in water.
Warm, soapy water or nonabrasive cleanser.
Damp cloth or nonabrasive pad.
Grease Trays and Drip Tray
Allow cooktop to cool completely before cleaning.
Warm, soapy water or nonabrasive cleanser.
Damp cloth or nonabrasive pad.
Module Basin
Warm, soapy water.
Nonabrasive pad or sponge.
For heavy soil, soak paper towels in household cleanser and
lay them on the soil for at least 30 minutes. After soaking,
scrub with a nonabrasive pad.
Oven Lights
The oven lights are 120-volt, 25-watt maximum halogen bulbs.
They will come on when the oven door is opened.
On 48" (121.9 cm) ranges, both the left and right oven lights
will come on when either door is opened. The oven lights will
not work during the Self-Cleaning cycle. When the oven door is
closed, touch OVEN LIGHT to turn light on or off.
26
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Disconnect power.
2. Remove glass light cover by grasping the front edge and
pulling away from oven.
3. Remove bulb from socket.
4. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage or decreasing the life of the new bulb,
do not touch bulb with bare fingers.
5. Replace bulb cover by snapping back into wall.
6. Reconnect power.
Oven Door
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven
doors.
Failure to do so can result in back or other injury.
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Using 2 or more people, lift the oven door while holding both
sides.
Continue to push the oven door closed and pull it away from
the oven door frame.