Oven Cavity; Problem Solver; Oven Lights - KitchenAid KODC304ESS Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OVEN CAVITY

Do not use oven cleaners.
Food spills should be cleaned after the oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
Cleaning Method:
Self-Cleaning cycle:
See "Self-Cleaning Cycle" first.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty page in this manual and scan the code there with your mobile device, or visit http://kitchenaid.custhelp.com. In Canada,
visit http://www.kitchenaid.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
KitchenAid Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
PROBLEM
Nothing will operate
Oven will not operate
Oven temperature too high
or too low
Display shows messages
Clean cycle did not work
on all spills
12

PROBLEM SOLVER

POSSIBLE CAUSES AND/OR SOLUTIONS
Oven isn't wired properly - See the Installation Instructions.
Household fuse is blown, or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
The control displays an F9 or F9 E0 error code - The electrical outlet in the home may be miswired.
Contact a qualified electrician to verify the electrical supply.
Delay Start is set - See the "Cook Time" section.
Control Lock is on - Press and hold START or START LOWER for 3 seconds to unlock.
Control is in Demo Mode - See the "Electronic Oven Controls" section. Demo Mode is used for display
models in a showroom.
Electronic oven control set incorrectly - See the "Electronic Oven Controls" section.
Oven temperature needs adjustment - See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
Power failure (display shows flashing time) - Press CANCEL or CANCEL UPPER to clear the display.
On some models, reset the clock, if needed. See the "Clock/Tools" keypad feature in the "Feature Guide"
section.
Error code (display shows letter followed by number) - Press CANCEL or CANCEL UPPER to clear
the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call for
service. See the "Warranty" section for contact information.
Several cooking cycles between Clean cycles or spills on oven walls and doors - Run additional
Clean cycles. The affresh
®
Kitchen and Appliance Cleaner can be used for stubborn soils. See the
"Accessories" and "Self-Cleaning Cycle" sections for more information.

Oven Lights

The oven lights are standard 40-watt appliance bulbs. Before
replacing, make sure the oven is cool and the controls are turned
Off.
To Replace:
1. Disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, and then bulb cover by turning clockwise.
5. Reconnect power.
In Canada:
KitchenAid Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Kosc504essKodc304ewhKodc304eKodc304ebl

Table des Matières