Disposal - MC Crypt DJ-500 U Notice D'emploi

Troubleshooting
A channel does not function.
• A connection cable has come off.
• The balance control on the amplifier or the mixer is set incorrectly.
The sound is distorted.
• The level on the mixer is set incorrectly or the connected amplifier is overmodulated.
• The connected device does not meet the requirements for the connection type or is not equipped with the
required connections.
• The volume on the connected amplifier is set too high.
CROSSFADER does not function.
• An unassigned channel has been chosen with the CROSSFADER ASSIGN A and B switch.
Channel A or B of the CROSSFADER are not audible.
• All three KILL switches of a channel are pressed simultaneously.
• Channel has been faded out using the CROSSFADER.
No signal of the effect processor is audible.
• EFFECTS ON switch has not been activated.
• EFFECTS LEVEL control set to minimum.
• An unassigned channel has been chosen with the SOURCE switch.
No microphone signal is audible.
• MIC ON switch has not been activated.
• MIC TRIM control set to minimum.
No signal is audible in the headphones.
• No channels have been selected for pre-listening with the MONITOR CUE switch.
• LEVEL control set to minimum.
No automatic BEAT ASSIST display.
• The input signal is too weak.
• An unassigned channel has been chosen with the CROSSFADER ASSIGN A and B switch.
Repairs other than those described above should only be carried out by an authorised
specialist.

Disposal

At the end of its service life, dispose of the product according to the relevant statutory regula-
tions.
41