MC Crypt DJ-500 U Notice D'emploi page 32

Connection and control elements
(13) MIX control:
Use this control to set the CUE/MASTER ratio for the headphones output. If the control is turned all the way to the
left, only the selected CUE channels are active. If the control is turned all the way to the right, only the MASTER
signal is fed to the headphones.
(14) LEVEL control:
Use the LEVEL control to set the volume of the headphones.
(15) PHONES connection:
Socket for stereo headphones (6.3 mm jack plug).
(16) MONITOR CUR switch:
Hold down the MONITOR CUE switch to listen to the channel via the headphones. Channels CH1 - CH4, the
MASTER channel and the EFFECTS channel can be switched to "pre-listening" simultaneously. The MONITOR
CUE LED lights up when the function is activated for the channel.
(17) MASTER LEVEL indicator
The MASTER LEVEL indicator shows the level of the MASTER output signal (44 and 52). The indicator should
not exceed "0dB", as otherwise the music signal can be distorted. Set the MASTER control (18) and the channel
fader (6) accordingly.
(18) MASTER fader
Use this fader to set the level of the MASTER output (44 and 52).
(19) MASTER BALANCE control
Use this control to set the left/right balance of the MASTER output (44 and 52).
(20) BOOTH LEVEL control
Use this control to set the level of the BOOTH output (45).
(21) CROSSFADER ASSIGN A and B switch
Use the CROSSFADER ASSIGN A and B switch to select the two channels to be controlled by the crossfader (22).
(22) Crossfader
Control to crossfade between the channels selected with the CROSSFADER ASSIGN A and B switches (21).
One channel is faded out using the slide control while the other channel is faded in. When the CROSSFADER is
in centre position, both channels are played equally.
30
If the MODE STERO/SPLIT switch (12) is set to SPLIT, the MIX control has no effect.
Turn the LEVEL control to MIN before plugging in or unplugging the headphones, before
putting on the headphones or before switching the mixer on or off. There is a risk of
damage to your hearing through excessive volume at the headphones output.
Do not select two identical channels with the two switches.