One-Shot Playback; Overdubbing; Loop Playback; Stop - Boss LOOP STATION RC-30 DUAL TRACK LOOPER Mode D'emploi

Overdubbing

Layer your performances while the
phrase plays as a loop.
Pressing the left pedal switches the
unit to playback.
• You can Undo and Redo (p. 11).

One-Shot Playback

The track for which one-shot has been specified will play only once.
Refer to "Specifying How a Phrase Will Play/Stop
(Stop Mode/One-Shot Playback)" (p. 10).
NOTE
* While phrase memory is being read, the PLAY (green) indicator will blink rapidly. Never turn off the
power while the PLAY indicator is blinking rapidly.
* The minimum recording time for a loop phrase is approximately 1.5 seconds. If you press the pedal within
approximately 1.5 seconds after you start recording, recording will continue until the phrase is at least
approximately 1.5 seconds long.
* The maximum recording time for a loop phrase is approximately 3 hours (total for all phrases). When the maximum
recording time is exceeded, the display will show "
or overdubbing may end before you intended. If this occurs, delete unneeded phrases (p. 10) and then try the
operation again.
* If you use the Memory Shift function before saving a phrase, that phrase will be erased. For details on how to save
a phrase, refer to p. 10.
Press the right pedal
" to indicate that internal memory is full, and recording
FL

Loop Playback

Play back phrases as loops.
Pressing the left pedal switches the
unit to overdubbing.
• To use the Memory Shift function, press the
[ ] / [ ] buttons while a phrase is playing;
the phrase memory number will blink,
allowing you to select the next phrase (p. 16).

Stop

Regardless of the timing, pressing
the right pedal will stop the current
track.
• If you want the two tracks to stop
simultaneously, press the right pedal twice in
succession.
Display Track 1
One shot
oL
Lo Loop
oo One shot
Basic Operation
Track 2
Loop
One shot
One shot
9