Installing Batteries - Boss LOOP STATION RC-30 DUAL TRACK LOOPER Mode D'emploi

Installing Batteries

Insert the included batteries as shown in the diagram, being careful to observe the correct polarity.
• Incorrect handling of batteries, rechargeable batteries, or a battery charger can cause leakage, overheating,
fire, or explosion. Before use, you must read and strictly observe all of the precautions that accompany the
batteries, rechargeable batteries, or battery charger.
• Batteries are supplied with the unit. The life of these batteries may be limited, however, since their primary purpose
was to enable testing.
• Be sure to observe the correct + (positive) and – (negative) orientation of the batteries.
• When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners
or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or
controls get damaged.
• When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.
• If the batteries run low, the display will indicate "
install fresh batteries as soon as possible.
• The use of an AC adaptor is recommended as the unit's power consumption is relatively high. Should you prefer to use
batteries, please use the alkaline type.
• Rechargeable Ni-MH batteries cannot be used.
• In some cases, all saved data might be lost if the batteries become depleted during recording or overdubbing (p. 7).
• When replacing the batteries, use six (AA, LR6) batteries.
• The contents of internal memory will not be lost when you replace the battery, but we recommend that you make
regular backups (p. 15) for safety's sake.
bt " and the POWER indicator will become dim. When this occurs,
3