MSA Super V Mode D'emploi page 6

INSPECTION
The Super V Helmet's useful life may
be affected by several things, includ-
ing heat, cold, sunlight and chemical
exposures. (See Useful Service Life
Section). Before and after each use,
inspect the helmet as follows.
Shell
1. Visually inspect the shell for brea
age, cracks, craze pattern, discol-
oration, chalky appearance, or any
other unusual condition.
2. Inspect the shell for brittleness by
flexing the brim. Any of the above
conditions can indicate a loss of
impact, penetration and/or electri-
cal resistance; and the helmet
must be replaced immediately.
TAL 905 (L) Rev. 7 - 10025122
INSPECTION
Suspension
1. Inspect for loss of flexibility of the
2. Inspect for cracks, breaks, frayed
Liner
Inspect for dents, cracks, flaking, or
other damage. If any of these condi-
tions are found, the entire helmet
must be replaced immediately.
Note: When replacing the suspension,
the liner must be removed from
the shell, and the surfaces of the shell
and liner that are not normally
visible should be inspected for the
above conditions. (See Helmet
Disassembly, Reassembly and Part
Replacement Section).
6
suspension.
straps or damaged stitching. If any
are found, the suspension must be
replaced immediately.