MSA Super V Mode D'emploi page 4

HELMET DESCRIPTION
The Super V Helmet meets the
requirements of the Canadian
Standard for Industrial Protective
Headwear CAN/CSA Z94.1-05, Class
E, Type II. This helmet is a system
consisting of a shell, suspension,
nylon sideshield and foam impact liner,
which work together as a unit.
This helmet is designed to provide
limited impact and penetration protec-
tion to the wearer's head in the event
of a top or lateral blow. It is also
designed to provide limited electrical
insulation protection.
HELMET ACCESSORIES
The Super V helmet with accessories
have not been tested to the require-
ments of CAN/CSA Z94.1. Use only
MSA supplied or approved acces-
sories with this helmet.
TAL 905 (L) Rev. 7 - 10025122
DESCRIPTION
1a.
ADJUSTING THE SUSPENSION
Fas-Trac ®
1. Open Fas-Trac headband by turn-
ing knob to the left as shown in
Figure 1.
2. Push top (inner)
crown strap
toward top of
protective hel-
met. Bottom
(outer) strap will
move in the
opposite direction, as shown.
3. Place helmet on head and push
down on top of helmet until a
comfortable and stable wearing
height is reached.
4. Tighten headband by turning knob
to the right. Tighten until snug fit is
obtained.
Note: The headband can be loosened
while the helmet is on your head by
repeating step 1.
Figure 1
4
Suspension
1b.