MSA Super V Mode D'emploi page 5

Staz-On® Suspension
1. Open napestrap
adjustment to
largest head
size* by squeez-
ing the ratchet
lock (per arrows
"A" in Figure).
Grasp telescoping portion of
napestrap (arrow "B") and slide to
maximum open position.
* Specific head sizes are not marked,
however, the Staz-On suspension cov-
ers the following head size ranges: 6-
1/2 to 7-1/4.
2. Push top crown
strap toward
crown of helmet;
bottom of crown
will move in
opposite direc-
tion.
3. Place helmet on head and push
down on top until comfortable
wearing height is reached.
4. Place hands at
back of head
and grasp ratch-
et lock ("A" in
illustration
above) between
right hand thumb
and forefinger and then slide tab
(C) with thumb in left hand..
5. Pull ratchet (A) and slide tab (C)
away from each other until com-
fortable fit is attained.
DESCRIPTION
A
B
C
A
A
C
Note: Napestrap can be loosened
while on the head by squeezing
ratchet lock with left hand and
pulling telescoping portion of
napestrap with right hand.
1 Touch™ Suspension
1. Push top crown
strap toward
crown of helmet;
bottom of crown
will move in
opposite direc-
tion.
2. Place helmet on head and push
down on top until comfortable
wearing height is reached.
3. Squeeze the
lock on the
napestrap to
loosen.
4. Squeeze the fin-
ger tabs on each
strap together to
tighten.
5
TAL 905 (L) Rev. 7 - 10025122