Specifications - Kenwood KRF-X9070D Manuel D'instructions

Specifications

AUDIO section
Rated power output during STEREO operation
DIN/IEC (20 Hz ~ 20kHz, 0.09 % T.H.D. at 6 Ω Ω Ω Ω Ω ) ...............................
............................................................................... 100 W + 100 W
Effective power output during SURROUND operation
FRONT (20 Hz ~ 20 kHz, 0.09 % T.H.D. at 6 Ω Ω Ω Ω Ω one channel driven)
............................................................................... 100 W + 100 W
CENTER (20 Hz ~ 20 kHz, 0.09 % T.H.D. at 6 Ω Ω Ω Ω Ω one channel
driven) .................................................................................. 100 W
SURROUND (20 Hz ~ 20 kHz, 0.7 % T.H.D. at 6 Ω Ω Ω Ω Ω one channel
driven) ................................................................... 100 W + 100 W
SURROUND BACK/SUBWOOFER (20 Hz ~ 20 kHz, 0.09 %
T.H.D. at 6 Ω Ω Ω Ω Ω one channel driven) ...................................... 100W
Total harmonic distortion ....................... 0.009 % (1 kHz, 50 W, 6 Ω Ω Ω Ω Ω )
Frequency response
(CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
................................................... 10 Hz ~ 100 kHz, 0 dB ~ –3.0 dB
PHONO 'RIAA' response .............. 40 Hz ~ 20 kHz, +1.5 dB ~ –3.0 dB
Maximum input level
PHONO (MM) .................................... 45 mV, 1 % T.H.D. at 1 kHz
Signal to noise ratio (IHF'66)
PHONO (MM) ........................................................................ 75 dB
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
............................................................................................... 95 dB
Loudness control
VOLUME at –30 dB level ...................................... +6 dB (100 Hz)
Input sensitivity / impedance
PHONO (MM) ........................................................... 4 mV / 47 kΩ Ω Ω Ω Ω
(CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
.............................................................................. 320 mV / 47 kΩ Ω Ω Ω Ω
Output level / impedance
TAPE REC ............................................................... 320 mV / 1 kΩ Ω Ω Ω Ω
PRE OUT (FRONT CHANNEL PREOUT) ....................1 V / 500 Ω Ω Ω Ω Ω
PRE OUT (CENTER CHANNEL PREOUT) ..................1 V / 500 Ω Ω Ω Ω Ω
PRE OUT (SURROUND CHANNEL PREOUT) ...........1 V / 500 Ω Ω Ω Ω Ω
PRE OUT (SURROUND BACK CHANNEL) ............... 1 V / 500 Ω Ω Ω Ω Ω
PRE OUT (SUBWOOFER) .......................................... 1 V / 500 Ω Ω Ω Ω Ω
Tone control
BASS ................................................................ ±10 dB (at 100 Hz)
TREBLE ............................................................ ±10 dB (at 10 kHz)
DIGITAL AUDIO section
Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Input level / impedance / wave length
Optical ........................... (–15 dBm ~ –24 dBm), 660 nm ±30 nm
Coaxial ......................................................................... 0.5 Vp-p / 75 W
Output level / impedance / wave length
Optical ........................... (–21 dBm ~ –15 dBm), 660 nm ±30 nm
Notes
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
52
EN
Caution : Read this page carefully to ensure safe
operation.
VIDEO section
VIDEO inputs / outputs
VIDEO (composite) ................................................. 1 Vp-p / 75 Ω Ω Ω Ω Ω
S VIDEO inputs /outputs
S VIDEO (luminance signal) ................................... 1 Vp-p / 75 Ω Ω Ω Ω Ω
S VIDEO (chrominance signal) ....................... 0.286 Vp-p / 75 Ω Ω Ω Ω Ω
COMPONENT VIDEO inputs/ outputs
COMPONENT VIDEO (luminance signal) ............. 1 Vp-p / 75 Ω Ω Ω Ω Ω
COMPONENT VIDEO (CB/CR-signal) ............. ±0.32 Vp-p / 75 Ω Ω Ω Ω Ω
FM tuner section
Tuning frequency range ................................. 87.5 MHz ~ 108.0 MHz
Usable sensitivity
MONO .................. 1.3 µV (75 Ω Ω Ω Ω Ω )/ 13.2 dBf (40 kHz dev, S/N 26 dB)
STEREO ........... 45 µV (75 Ω Ω Ω Ω Ω )/ 42.1 dBf (40 + 6 kHz dev, S/N 46 dB)
Total harmonic distortion
MONO (1 kHz, 40 kHz dev) ....................... 0.2% (65.2 dBf input)
STEREO (1 kHz, 40 + 6 kHz dev) ............... 0.8% (65.2 dBf input)
Signal to noise ratio (DIN weighted at 1 kHz)
MONO ........................................................ 65 dB (65.2 dBf input)
STEREO ..................................................... 60 dB (65.2 dBf input)
Stereo separation (1 kHz) ........................................................... 36 dB
Selectivity (DIN ±300 kHz) .......................................................... 64 dB
Frequency response (30 Hz ~ 15 kHz) .................... +0.5 dB, –3.0 dB
AM tuner section
Tuning frequency range .................................... 531 kHz ~ 1,602 kHz
Usable sensitivity (30% mod, S/N 20 dB) ......... 16 µV / (600 µV/m)
Signal to noise ratio (30% mod, 400 Hz) ............................................
.................................................................. 50 dB (60 dBµV EMF input)
GENERAL
Power consumption .................................................................. 330 W
Standby Power consumption ....................................... less than 2W
AC outlet
SWITCHED ........................................................ (total 90 W max.)
Dimensions ..................................................... W : 440 mm (17-5/16")
Weight (Net) .............................................................. 9.8 kg (20.6 lb)
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below. Refer
to the model and serial numbers whenever you call upon your dealer for
information or service on this product.
Model __________________ Serial Number ________________________
H : 159 mm (6-1/4")
D : 392 mm (15-7/16")